Telemetry Transmitter for Small Animal

The goal of this project was to build a small, cheap, light-weight telemetry transmitter to attach to a small animal. This version uses a commercial, low-power transmitter, the Radiotronix RCT-433-AS. The design worked well, but has a relatively high current draw of about 500 microamps. A CR1620 lithium coin cell runs the circuit for about a week. The current version uses a pair of CMOS oscillators to produce a chirp once per second.

The circuit shown above has two standard CMOS multivibrators. The second is gated by the first. The duty cycle of the first oscillator is about 1%, or 10 mSec every second. A logic-high at the telemetry transmitter control turns it on.


The circuit board was layed out using ExpressPCB software. You will need to download a copy to view the design file. The components are all surface mount. The dots shown below are on a 0.1 inch grid.


Note the antenna lead at the lower left. At 433 MHz (70 cm wavelength) a quaterwave antenna should be 17 cm long. The battery is partly shown at the right. It is a CR1620 lithium cell, but any 3 volt source may be used. The transmitter module sticks out to the left. Visit page

read more "Telemetry Transmitter for Small Animal"

Small AM Transmitter Circuit

This schematic is AM transmitter circuit. This ircuit is deliberately limited in power output but will provide amplitude modulation (AM) of voice over the medium wave band.It is illegal to operate a radio transmitter without a license in most countries.

The circuit is in two halfs, an audio amplifier and an RF oscillator. The oscillator is built around Q1 and associated components. The tank circuit L1 and VC1 is tunable from about 500kHz to 1600KHz. These components can be used from an old MW radio, if available. Q1 needs regenerative feedback to oscillate and this is achieved by connecting the base and collector of Q1 to opposite ends of the tank circuit. The 1nF capacitor C7, couples signals from the base to the top of L1, and C2, 100pF ensures that the oscillation is passed from collector, to the emitter, and via the internal base emitter resistance of the transistor, back to the base again. Resistor R2 has an important role in this circuit. It ensures that the oscillation will not be shunted to ground via the very low internal emitter resistance, re of Q1, and also increases the input impedance so that the modulation signal will not be shunted. Oscillation frequency is adjusted with VC1.
Q2 is wired as a common emitter amplifier, C5 decoupling the emitter resistor and realising full gain of this stage. The microphone is an electret condenser mic and the amount of AM modulation is adjusted with the 4.7k preset resistor P1.
An antenna is not needed, but 30cm of wire may be used at the collector to increase transmitter range.

read more "Small AM Transmitter Circuit"